Stick the vapor barrier material to the foundation seal tape and then use mechanical fasteners to hold it forever.
Attaching plastic sheeting to concrete.
Each anchor consists of an unthreaded pin set into a metal sleeve.
Use for a rigid bond.
Apply construction adhesive to the wall.
Use the pencil to trace around the plastic object on the concrete where the two touch making an outline.
This article will show you how to add 6 mil plastic sheeting on the ground and insulate the walls in your crawlspace.
This is an old stone foundation where the mortar has mostly turned to sand.
This should be a place where part of the plastic item can press relatively flat against the concrete and cover enough surface area to support its weight.
Start along the top edge with a thick bead of adhesive and work downwards.
Attach plastic to wall hold the plastic up over the wall you want to cover and use a utility knife to cut around extrusion such as windows and pipes.
If you drill through the seal tape you will prevent the plastic from peeling off when you remove the drill.
Pierce the plastic or foil seal inside the base of the tube nozzle with a long thin object such as a skewer long nail or the rod that is attached to the side of some caulk guns.
Hold plastic sheeting up to the wall and press into place when properly positioned.
Drill holes through the plastic and through the seal tape into the block.
A polyurethane glue which is perfect for use where a waterproof bond is required e g.
Start at the top of the wall and work over then down both pressing pulling and smoothing as you go.
We use foil faced rigid insulation to keep the space under the house dry.
Press the plastic against the cement and find a good location to seat it.
The plastic and the insulation will eliminate any moisture problems you have in the crawlspace such as water droplets collecting on the concrete walls.
6 recommended products for sticking plastic to cement concrete brick 6 results.
Some parging was put up so we have something between the plastic and stone.