1 2 inch 1 3 cm plywood or osb are common substrates and these are generally covered with roofing felt or another moisture barrier prior to siding the walls.
Attaching vinyl siding to concrete wall.
But if you want a garage that is both sturdy and attractive you may want to cover your garage s exterior concrete block wall surface with something more becoming than the concrete block.
One choice might be vinyl siding.
The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick.
If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing.
Although the process of installing vinyl siding is relatively simple it helps to have assistance.
Add vinyl siding strips until you reach the end of the wall then measure and cut the last strip to leave 1 4 inch space at the end.
There are at least three alternative ways to do it.
The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor.
Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well.
A concrete block garage is just about as sturdy as any garage can be.
Use the cut off piece to start the next row of siding.
Installing vinyl siding over concrete is similar to installing it over wood since you have to install wooden furring strips under the siding.
As a result the osb protrudes about a half inch farther out than the concrete.
On hot days because the siding will contract when the temperature drops.
Installing 2 inch wide treated strips is necessary for a solid base for the house siding.
Remove any siding or exterior finish that isn t compatible with vinyl siding and make sure the walls are sheathed with a substrate to receive the siding.
This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole.
Always refer to the installation guide on the particular vinyl siding that you re installing but most vinyl siding panels should overlap each other by at least an inch.
The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house.
For attaching something relatively light to concrete it s hard to beat the speed and ease of hammer set anchors each anchor consists of an unthreaded pin set into a metal sleeve.