Step 2 reattach downspouts.
Attch loose gutter downspout to house.
If the boards under the gutter won t hold nails then you have too choices.
One way to make sure your gutter doesn t fall off the house is to install fascia hanger brackets.
There are strap type hangers that go under the shingles.
You must affix the gutter downspouts to the wall after they are connected to the upper gutter system however for the best drainage.
Instead the roof often overhangs the wall below so it is necessary to add a couple of elbows that allow you to connect to the overhead gutter at an angle so the downspout is flush with the wall.
Attach a masonry bit to your drill and drill a hole into the stucco.
Remove all gutter spikes from along the loose or sagging areas of your gutter using a drill.
Metal or vinyl downspouts this versatile downspout has a lifetime guarantee.
A downspout is installed by fitting it over the drop outlet on the gutter and screwing downspout supports to the wall of the house.
Just hook the bracket under the front lip of the gutter and then screw the other side of the bracket to the fascia.
Gutters are hung using gutter hangers or brackets.
On plastic gutter i think the gutter just snaps into the hanger.
Drill a hole wide enough for the anchor tap it into the stucco and then attach the downspout clamp and screw a 6 2 inch screw into the anchor.
Step 3 replace decayed downspouts.
Leave the old spikes in place a spike head looks better than a hole in the gutter.
Use the downspout to redirect runoff and help prevent garden erosion and foundation damage.
Compatible with 2 in.
This durable downspout is maintenance free and has uv stabilizers to help prevent uv light degradation.
Loose sections can bend or crack if there are consistent winds.
Again attempt to find the housing studs but if this doesn t work the use of anchors will be necessary.
Downspouts should be installed with a minimum of elbows because elbows are where clogs are most likely to happen.
Put one screw in on either side of the downspout.
These short screws are visible from the front of the gutter farthest from the house and pass through.
Using the sheet metal screws and the drill drive two screws into the top of the downspout attaching it to the gutter.
On the side of my house there is a downspout which has become free from the side wall.
Guttering elbows generally attach directly to the underside of the gutter with a screw and again at the downspout with another screw.